Tuesday, November 19, 2024

Someone went wild with a drill

 


15 comments:

  1. Not a drill , a metal punch

    ReplyDelete
  2. When its all about shaving every damned ounce...Kool!

    ReplyDelete
    Replies
    1. I wonder if they weighed all the metal they removed to find out.

      Delete
    2. Then you find out the driver is 20 lbs. overweight...

      Delete
  3. speed is always weight against horsepower. and shaving every ounce you can safety remove is golden. a lot of punch and flange work is needed to really do a good job of it.

    ReplyDelete
  4. Just don't try to power shift or all you'll have in your hand is the knob and part of the column.

    ReplyDelete
  5. Just buy a bigger engine and forget the hole punch. Stupid story - when my mom was in high school, circa1950, two guys were racing in borrowed cars, one of the shifted too hard and broke the shift lever off.

    ReplyDelete
    Replies
    1. You' ll break your wrist but not a Hurst.

      Delete
    2. We ran muncy 4 speed rock crushers. Almost grenade proof. Almost…

      Delete
  6. Mind the ounces and the pounds take care of themselves! I'd say they used a step bit for the smaller holes, some of those parts would be hard to remove.

    ReplyDelete